How do I reset the bobbin tension?

Why is my thread looping underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

How do I adjust the tension on my brother bobbin?

The bobbin case installed in this machine can be adjusted, if necessary, to accommodate the bobbin tension for embroidering.

  1. Using a small slotted screwdriver, turn the slotted head (-) screw to adjust the bobbin case tension. …
  2. The thread tension is correct when upper thread slightly appears on the wrong side of fabric.

Why is my bottom stitch not straight?

If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.

How do I stop my sewing machine from looping?

Looped stitches are usually caused by improper tension. If the loop is on the upper side, it may be corrected by loosening the top tension or by tightening the lower tension. If the loop is on the under side, it is usually best corrected by adjusting the upper tension.

THIS IS FUNNING:  What beads do not fade?

Why is my bottom stitch bunching up?

Make sure that you are using the same weight thread in both your bobbin and upper thread. If you don’t, your tension can be uneven and cause you to get bunched-up thread under your fabric. … If your tension is too tight, it can pull your thread and break it. Turn your tension dial counterclockwise to loosen it.

What should the tension be on a Brother sewing machine?

a. The tension dial should be set between 2 to 6. b. When the upper thread is just visible on the back of the fabric, the thred tension is correct.

What is the correct tension for a Brother sewing machine?

The normal tension setting is 4.0. The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and the bobbin thread should be visible from the wrong side of the fabric.