Why won’t my sewing machine do a zigzag stitch?

What tension should you use for a zigzag stitch?

The dial settings run from 0 to 9, so 4.5 is generally the ‘default’ position for normal straight-stitch sewing. This should be suitable for most fabrics. If you are doing a zig-zag stitch, or another stitch that has width, then you may find that the bobbin thread is pulled through to the top.

Why is my zig-zag stitch coming out straight?

If the upper thread appears as a single line, the lower thread is incorrectly threaded. Instead of the appropriate tension being applied to the lower thread, it is pulled through the fabric when the upper thread is pulled up.

Why is my stitch not catching?

Skipped stitches can mean one of two things: needle issues or disrupted timing. First, your needle may be dull or damaged and needs to be replaced. You should also check that you are using the correct needle for the type of fabric you are sewing.

What settings should my sewing machine be on?

Most sewing is done in the 2.0 to 2.5 range. If you are foundation paper piecing, you may want to decrease your stitch length so that the paper tears away easier. Top stitching and quilting are usually done in the 3.0 to 3.5 range. Basting and gathering stitches are the longest, from 4.0 – 5.0.

THIS IS FUNNING:  What Colours were used in Roman mosaics?

Can I use a zigzag stitch with a walking foot?

Yes, you can use your walking foot for more than straight stitching. A zig-zag stitch should be just fine because all the movement in the stitch pattern is forward. In fact many of the decorative stitches on your sewing machine are just fine to use with your even feed foot installed.

Why is my bottom stitch not straight?

If your thread is pulled tight on the underside and not forming an even stitch then (counter-intuitively) it’s usually the top thread tension that’s wrong. Sometimes very lightweight fabrics such as sheers can get dragged down into the machine so it’s a good idea to use a straight stitch plate.

Why is my thread bunching underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

Why won’t my sewing machine needle go up and down?

A disengaged clutch, broken drive belt or internal drive gear failure can prevent the needle from moving. … If the needle won’t move with the clutch engaged, unplug the sewing machine and check the drive belt. Replace the drive belt if it’s broken.

How do you fix an uneven stitch on a sewing machine?

The Problem: Stitches are coming out uneven or skipping entirely. THE SOLUTION: Odds are, the secret culprit here is a needle that is broken, bent, or otherwise damaged. Experts recommend that you replace your needles for every 16 hours of stitching time.

THIS IS FUNNING:  Your question: How do you cut plastic bags in knitting?

What to do when sewing machine is not sewing?

Machine is not sewing any stitches while trying to sew

  1. The machines top thread may not be threaded correctly. …
  2. Make sure the needle thread is behind the needle bar thread guide on the needle bar.
  3. The thread may be knotted or tangled. …
  4. The thread may be too thick for the needle.