Frequent question: How do I adjust the bobbin thread?

Why can’t I raise the bobbin thread?

Check the upper thread. – Check to see if your upper tension is too tight. … – Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. – Make sure that the upper thread is threaded properly.

Why is my thread bunching underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.

Why won’t my sewing machine needle go up and down?

A disengaged clutch, broken drive belt or internal drive gear failure can prevent the needle from moving. … If the needle won’t move with the clutch engaged, unplug the sewing machine and check the drive belt. Replace the drive belt if it’s broken.

What is the normal tension setting on a Singer sewing machine?

The target figure should be around 30 to 40g. (1-1/4 to 1-1/2 oz) but it does not have to be too precise. However most people don’t have a spring balance handy, so alternatively you can tie a weight of the correct amount onto the thread and then jerk the bobbin gently upwards.

THIS IS FUNNING:  What kind of yarn can you brush out?

Why is my sewing machine so tight?

If the bobbin case falls several inches, the bobbin tension is too loose. If the bobbin doesn’t fall at all, the bobbin tension is too tight. There is a small screw on the side of the bobbin. Using the screwdriver in your machine tool kit, turn the screw a quarter-turn right to tighten, left to loosen.